Once everything is properly connected, be sure to follow the procedure below to turn on their power. If you turn on equipment in the wrong order, you risk causing malfunction or equipment failure.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after turning the unit on is required before it will operate normally.
Turning the Power On
1. Connect the peripheral devices.
Connect any video cameras and other equipment. Make the connections while the power to all equipment, including the V-40HD, is turned off.
2. Turn on the power to the V-40HD.
Make sure the power cable is securely inserted, then press the [POWER] button located on the rear panel. The buttons and indicators on the top panel flash, and the V-40HD starts up.
3. Turn on the power to the source devices.
Turn on the power to the source devices such as video cameras connected to the V-40HD.
4. Turn on the power to the output devices.
Turn on the power to the output devices such as projectors connected to the V-40HD.
Turning the Power Off
1. Turn off the power to the output devices.
Turn off the power to the output devices such as projectors connected to the V-40HD.
2. Turn off the power to the V-40HD.
Set the [POWER] switch on the rear panel to OFF to turn off the power to the V-40HD.
3. Turn off the power to the source devices.
Turn off the power to the source devices such as video cameras connected to the V-40HD.
Never turn off the power while a message such as “Processing...” is shown in the menu display area of the preview monitor. Doing so might cause settings not to be saved properly.