In DD-500 System Program Ver.2 or later, a 'TEMPO HOLD' parameter has been added, allowing you to specify whether to change or maintain the tempo (BPM) when switching patches.
Perform the steps below:
- Press the [EDIT] button.
- Use the [▼] [▲] buttons to navigate to “SYSTEM”, then press the [EDIT] button.
- Use the [▼] [▲] buttons to navigate to “TEMPO HOLD”.
TEMPO HOLD: Specifies whether tempo (BPM) changes or is maintained when you switch patches. Maintaining the tempo also lets you maintain the delay time. However, the delay time will also change if the NOTE setting (such as ♩ or ♪) of the newly selected patch differs from that of the previous patch. You can change this setting for each patch. - Use the [TIME/VALUE] knob and set to “ON”.