The following article addresses general noise issues when using the OCTA-CAPTURE with a computer:
- First try performing a factory reset. This is a good starting point for troubleshooting.
Note: If you don't want to lose the settings, you may perform a backup. - Follow the troubleshooting info in the following article--as noise issues are often a result of grounding problems:
http://cms.rolandus.com/assets/media/pdf/Resolving_Grounding_Problems.pdf -
For troubleshooting purposes, disconnect all USB devices except the mouse and the OCTA-CAPTURE—this includes disconnecting the computer keyboard, printer (if applicable), USB hub and/or USB breakout box, etc). If the noise disappears, troubleshoot the device introducing the noise.
-
Physically disconnect any cables connected to any inputs or outputs of the OCTA-CAPTURE and troubleshoot with headphones--this means that a USB cable and headphones are the only cables physically connected to the OCTA-CAPTURE.
NOTE: Be sure that speakers are not connected to the OCTA-CAPTURE and the speakers are not plugged into any power outlets for this troubleshooting.
If the problem disappears, the noise is being introduced from one of the audio cables or the speakers themselves. Start reconnecting cables, one by one, until the noise is reintroduced. -
Be sure that you are using balanced cables connected from the OCTA-CAPTURE's outputs into your speakers. If the noise still continues, try using ground lifts on your speakers (if you have these available) as you may have a grounding issue.
If the problem continues, leave all cables physically disconnected from the OCTA-CAPTURE, except for the USB and headphones, and continue the troubleshooting: -
Try connecting the OCTA-CAPTURE directly to each USB port on your computer (do not use a USB hub or USB breakout box for this test)—to rule out one or more USB ports causing the problem.
-
Move the OCTA-CAPTURE away from your computer video monitor—as the video monitor may be introducing this noise.
- Move the OCTA-CAPTURE away from the computer itself--as the computer's power supply could be introducing this noise.
-
Disconnect the OCTA-CAPTURE and test with the computer’s internal soundcard. If the noise problem continues, the OCTA-CAPTURE is not the cause of the problem.
-
Connect the computer’s power, and the computer video monitor’s power to a different power circuit. The noise may be a result of dirty power or another issue from the original power circuit. Be sure that your computer's power, your computer's video monitor's power, the OCTA-CAPTURE's power and your speakers power are all connected to the same outlet--on the same circuit.
- Test with a different USB audio interface (if available) to determine if the issue is isolated to the OCTA-CAPTURE or with any USB audio interface.
-
Test on a different computer to determine if there is an issue with the OCTA-CAPTURE that continues on a different computer system.