You can have the ACCEL/CTL pedal switch more than one EFFECT ON/OFF using the CTL ASSIGNS.
There are 8 ASSIGNMENTS available per PATCH. So technically you could control 8 parameters with the ACCEL/CTL.
Note: ASSIGNMENTS are a little more complicated programming and if you do use them then set the ACCEL/CTL to FUNC: LED ON/OFF and program functionality using the CTL ASSIGNS instead.
For example using ACCEL/CTL PEDAL to control OD/DS and DELAY ON/OFF using ASSIGNMENTS.
PRESS [CTL/EXP] for CLT/EXP MENU, use KNOB 4 to select ACCEL/CTL icon, in the ACCEL/CTL MENU settings:
FUNC: LED ON/OFF
MIN: OFF
MAX: ON
SOURCE MODE: TOGGLE
Return to CLT/EXP MENU (Left Display):
Use KNOB 4 to select 1 CTL ASSIGN icon, in the ASSIGN 1 MENU settings (Right Display):
ASSIGN OFF/ON: ON
SOURCE: ACC/CTL PDL
SOURCE MODE: TOGGLE
Press [PAGE >] arrow RIGHT to ASSIGN 1, PAGE 2 MENU settings (Right Display):
TARGET CATEGORY: OD/DS
TARGET: ON/OFF
TARGET MIN: OFF
TARGET MAX: ON
Return to CLT/EXP MENU (Left Display):
Use KNOB 4 to select 2 CTL ASSIGN icon, in the ASSIGN 2 MENU settings (Right Display):
ASSIGN OFF/ON: ON
SOURCE: ACC/CTL PDL
SOURCE MODE: TOGGLE
Press [PAGE >] arrow RIGHT to ASSIGN 2, PAGE 2 MENU settings (Right Display):
TARGET CATEGORY: OD/DS
TARGET: ON/OFF
TARGET MIN: OFF
TARGET MAX: ON
Now that your ASSIGNMENTS are programmed:
Press [EXIT] and Press [EFFECT] to enter FX CHAIN VIEW and check functionality of your ACCEL/CTL and visual and audio check the OD/DS and DELAY EFFECTS.
If all is functioning correct, Press [WRITE/SAVE] twice to WRITE/SAVE your settings to the current PATCH location.
Press [EFFECT] and use KNOB 4 to select the OD/DS or DLY EFFECTS (Left Display) and make your customized settings (Right Display).
If all is functioning correct, Press [WRITE/SAVE] twice to WRITE/SAVE your settings to the current PATCH location.