The following information is from the VR-4HD Owner's Manual.
If you would like more information on this topic, please contact support via Roland Backstage.
Saving a Memory
1. Press the [SYSTEM SETUP] button to display the setup screen.
2. Select <MEMORY> to display the MEMORY menu.
3. Select <SAVE> to display the MEMORY SELECT screen.
4. Select the memory where you want to save the settings.
5. Select <SAVE>.
6. Check the message, then select <OK>.
(If you want to quit, select <CANCEL>.)
The current settings are saved.
7. Press the [SYSTEM SETUP] button several times to quit the setup screen.
- The state of the [OUTPUT FADE] button on the operation panel is not saved in memory.
The following settings are also not saved in memory. Only a single set is saved in the unit.
* “COLOR BAR OUTPUT” and “TEST TONE OUTPUT” are always set to “OFF” at startup.
