MS-3: How to Program CTL IN 3 with Noise Suppressor On/Off for FS-7
FS-7 Foot Switch Setup:
Set the MODE to FS-5U MOMENTARY
POLARITY: 1
Using a 1/4" TRS cable connect the FS-7 A+B jack to the MS-3: CTL IN CTL 3/4 jack.
MS-3 Setup:
First turn OFF CTLIN 3 quick menu FUNCTION.
From MS-3 USER PATCH PLAY SCREEN,
Press [EDIT] to enter EFFECT CHAIN VIEW.
Use VALUE KNOB 1 to select "CTL" icon and press [ENTER] to access the "CTL, ASSIGN&MIDI SETTING" menu.
Use any VALUE KNOB to select "CTLIN3" and press [ENTER], use VALUE KNOB 1 to set "FUNC" to OFF and press [EXIT].
Setup MS-3 ASSIGN 1 for NS On/Off:
Now use any VALUE KNOB to select "ASSIGN1"and press [ENTER].
ASSIGN 1 Settings will be as follows:
ASSIGN 1 MENU PAGE 1
ASSIGN: ON
SOURCE: CTL IN 3. NOTE: you can choose CTL IN 1,2,3 or 4.
MODE: TOGGLE
Press [PAGE >/ENTER] to go to PAGE 2
ASSIGN 1 MENU PAGE 2
CATEGORY: NS for Noise Suppressor
TARGET: ON/OFF
Press [PAGE >/ENTER] to go to PAGE 3
ASSIGN 1 MENU PAGE 3
MIN: OFF
MAX: ON
Press [PAGE >/ENTER] to go to PAGE 4
ASSIGN 1 MENU PAGE 4
ACT.LOW: 0
ACT.HIGH: 127
Test ASSIGN 1 Programming:
Once ASSIGN is programmed press [EXIT] twice, use VALUE KNOB 1 to select "NS" icon.
Check and test FS-7 button B is switching NS ON/OFF.
WRITE/SAVE Settings to PATCH Location:
If functioning correct make sure to WRITE/SAVE settings to USER PATCH.
Press [EXIT+ENTER] to access WRITE UTILITY MENU, use any VALUE KNOB and select WRITE to enter PATCH WRITE MENU,
Use VALUE KNOB 1 to select TARGET PATCH number, if WRITE/SAVING to the same PATCH location there's no need to use the VALUE KNOB,
press [ENTER] twice to EXECUTE and SAVE programming to the PATCH LOCATION.