TD-50: Assigning the Built-In Click to a Direct Output

It's possible to assign the TD-50's on-board Click to one of the Direct Outputs. Here's how:

1. Press the [SETUP] button.
   The SETUP MENU screen appears.
   
2. Press the PAGE [UP] button to confirm that you're on "SETUP page 1."
   
3. Press the [F1] button (OUTPUT).
4. Press PAGE [UP] or [DOWN] button to select page 2 ("OTHER OUTPUT").
   
5. Press the [F2] (DIRECT) button.
   
6. Press the cursor right button to highlight "CLICK."
   
7. Turn the dial to move the indicator to the desired DIRECT 'line' (1-8).
   You can also assign other parameters to the Direct Outputs while in this same menu.
8. Press the [KIT] button when you're finished.
   The new setting is saved automatically.