DJ-202 USB Mode Setting, Vendor or Generic
Note: To use the USB Vendor mode you must have the Driver installed in your computer.
1. While holding down the [LOAD] button at the right side (R channel) of the browser section, use a USB cable to connect the DJ-202 to your computer; continue holding down the [LOAD] button until the SEQUENCER section’s [START/STOP] button blinks. The DJ-202 is in system setting mode.
2. Press the performance pad that corresponds with the setting you want to make. The MASTER level indicator is lit, indicating the current value of the setting.
R channel PAD [1] = USB mode setting
Set this as appropriate for the USB driver that you’re using.
Generic (One side of the MASTER Level indicator is lit) Choose this if you want to use the generic USB driver provided by your
computer’s operating system.
* If the USB mode is set to Generic, you can not use Serato DJ Intro /
Serato DJ.
Vendor (Both Sides of the MASTER indicator are lit) Choose this if you want to use the dedicated DJ-202 USB driver that you
downloaded from the Roland website.
3. Use the rotary selector to change the value of the setting.
4. When you’ve finished making settings, press the blinking [START/STOP] button. All of the MASTER level indicators are lit, and then all buttons and pads blink.
5. Disconnect the USB cable to power-off the DJ-202.