KATANA-50: Version 2.02 Foot Switch Options FS-6 and FS-7
For KATANA-50 SYSTEM UPDATE VERSION 2.02 users will have 4 Channels available to
program and WRITE/SAVE USER settings and have an added 3 effects.
For the KATANA-50 amp using System Program Update Version 2.02 use the following Foot
Switch options:
- BOSS FS-6 (9 Volt, battery power only) A/B Foot Switch.
- BOSS FS-7 (Power Supply only) A/B Foot Switch.
Connect using a 1/4" TRS Stereo Cable from the Foot Switch A+B JACK to the KATANA-50
FOOT CONTROL JACK located on the KATANA-50 back panel.
Set the FS-6 or FS-7 to LATCH MODE.
Functionality and normal operation will be as follows for the FS-6 or FS-7:
A = Press [A] for BANK UP/DOWN.
NOTE: KATANA LED indicators for CHANNEL and PANEL will be lit, CHANNEL (number 1 or 2) will
be SOLID RED and PANEL will be blinking RED, this is the visual designation for BANK B.
B = Press [B] for Channel Switching, CH 1A/2A and CH 1B/2B.
NOTE: When in BANK A or BANK B, pressing the Foot Switch [B] will toggle between
Channels 1 and 2.
If the KATANA-50 user is already using a BOSS FS-5L and would like to add functionality
supporting Version 2.02 then an additional BOSS FS-5L pedal is needed.
https://www.boss.info/us/products/fs-5u_5l/
Two FS-5L pedals can be connected and used together, however an INSERT Y-CABLE is
necessary, please see below.
NOTE:
FS-5L = LATCHING (YES KATANA COMPATIBLE) and
FS-5U = MOMENTARY (NOT KATANA COMPATIBLE)
Connect using an Insert Y-Cable, 1/4" TRS Stereo cable end to 2 - 1/4" TS Mono cable ends.