If the values for Cutoff, Resonance or other parameters are changing by themselves even though you’re not playing back a pattern in which motions have been recorded, this may be because the D-MOTION function is enabled.
When D-MOTION is on, the values of the parameters assigned to D-MOTION change according to how the SH-4d is tilted. To make the values stop changing due to D-MOTION, you must turn D-MOTION off.
* For details on how to configure D-MOTION, refer to “Using D-MOTION”.
* The output values for the parameters assigned to D-MOTION are “0” when the SH-4d is placed on a level surface.