GM-800 : Factory Reset (Initialization) Instructions

Restoring the factory settings (Factory Reset)

Restoring the GM-800’s settings to their original factory default settings is referred to as a “Factory Reset”. You can restore all the settings to their factory-set default values, or alternately, you may also specify specific items to be reset.
* When you execute a “Factory Reset”, the customized user settings will be erased/initialized.

Before performing a Factory Reset, when possible, save any custom user data to your computer using the dedicated software, or alternately create a backup to a USB flash drive.

1. Press [MENU] button, use PAGE [>] navigate to FACTORY RESET, and press the [2] KNOB to enter the FACTORY RESET menu.
   
2. Turn the [1] KNOB to select the item/s you want to reset to factory defaults, and press the [1] knob to select the checkbox.
   Note: depending on angle of the display and contrast, you should see a slight gray square selection cursor, see below.
   

   Item	Explanation
   Reset User Data	Initializes the scenes and imported tones
   Reset System Data	Initializes the system parameters
   Remove License (*1)	Initializes the user license and WAVE EXPANSION. Initializing the user license lets you import/install a SOUND PACK or WAVE EXPANSION that was downloaded with a different user license. This deletes the currently installed WAVE EXPANSION

   * 1 This is displayed if a SOUND PACK or WAVE EXPANSION is imported/installed.
   
   
3. Press the [WRITE] button to execute, then press [4] KNOB for OK confirmation.
   Alternately, if necessary to cancel the Factory Reset, press the [3] KNOB for CANCEL.
   
   When the Factory Reset is complete, the message “Completed" appears.
   * Never turn off the power or disconnect the USB flash drive during a process, such as while the “Executing…” display is shown.
   
   
4. After Factory Reset, recycle power.
   Turn the power of the GM-800, OFF and then ON again.