Backup
1. Hold down [ 1 ] and switch on the power.
2. Connect the computer to the VT-3's USB port by a USB cable.
3. Open the "VT-3" drive folder in your personal computer.
4. Copy VT-3 memory files in "BACKUP" directory into your personal computer.
Memory 1 - 6 : VT3_PATCH1.PRM - VT3_PATCH6.PRM
5. After Copying the file is completed, disconnect the USB cable.
Windows : Right-click on the "VT-3" icon in My Computer and execute "Eject".
Mac : Drag the "VT-3" icon to the Trash icon in the Dock.
6. Turn the VT-3 power off.
Restore
1. Hold down [ 1 ] and switch on the power.
2. Connect the computer to the VT-3's USB port by a USB cable.
3. Open the "VT-3" drive folder in your personal computer.
4. Copy VT-3 memory files into "RESTORE" directory.
5. After Copying the file is completed, disconnect the USB cable.
Windows : Right-click on the "VT-3" icon in My Computer and execute "Eject".
Mac : Drag the "VT-3" icon to the Trash icon in the Dock.
6. Turn the VT-3 power off.
Extended Memory
Press [ 1 ][ 2 ][ 3 ] buttons with holding down [ MANUAL ] button to select 4,5,6.
Adjust character level balance
MIDI implementation by USB MIDI
Receiving midi channel is OMNI, Transmitting midi channel is 3.
Note
Pitch correction for AUTO PITCH 1/2/Megaphone/Radio/Scatter
Pitch correction for synth note of VOCODER/SYNTH/LEAD/BASS
Program change
Select memory number
Control Change
Change button/slider/pedal parameter
CC#12 = pitch
CC#13 = formant
CC#16 = mix balance
CC#17 = robot
CC#18 = bypass by button
CC#19 = bypass by pedal
CC#91 = reverb level
Add low cut filter to avoid sensing low frequency sound
Turn [ CHARACTER ] encoder with holding down [ ROBOT ] button.
Its range is from 50 - 500 Hz, its step is 50 Hz.
It is bypassed when all character LED are OFF.
Add noise gate to avoid howling sound
Turn [ CHARACTER ] encoder with holding down [ BYPASS ] button.
The bigger this setting is, the bigger noise gate level is.
It is bypassed when all character LED are OFF.
Add USB attenuator
1. While holding down the [ MANUAL ] button, turn on the power.
2. Turn [ CHARACTER ] encoder with holding down [ BYPASS ] button.
3. Press the [ BYPASS ] button to save.
The bigger this setting is, the lower the level is.
It is normal level when all character LED are OFF.
Audio level in IN BYPASS port is not change.
Demo mode
1. While holding down the [ MANUAL ] button, turn on the power.
2. Move [REVERB] slider with holding down [ MANUAL ] button to set the time (minute) to start.
3. Press the [ BYPASS ] button to save.