The Roland GR-30 allows you to turn the Arpeggiator on or off (for each Patch
utilizing the Arpeggiator) using the built-in footpedals. To turn the
Arpeggiator on or off, use one of the following two procedures:
PROCEDURE 1
1) Select a Patch that utilizes the Arpeggiator, such as A11. Note the green
LED under "ARP/HAR" is lit, indicating the Arpeggiator is on.
2) Use the PARAMETER SELECT dial to select PATCH INC/DEC BY S1/S2.
3) Press PEDAL 4 to turn the Arpeggiator off.
4) Press PEDAL 4 again to toggle the Arpeggiator on or off.
PROCEDURE 2
1) Select a patch that utilizes the Arpeggiator, such as A11. Note the green
LED under "ARP/HAR" is lit, indicating the Arpeggiator is on.
2) Use the PARAMETER SELECT dial to select anything other than PATCH INC/DEC
BY S1/S2.
3) Press the S2 button on your GK-2A Pickup.
4) Press PEDAL 4 to turn the Arpeggiator off.
5) Press PEDAL 4 again to toggle the Arpeggiator on or off.
utilizing the Arpeggiator) using the built-in footpedals. To turn the
Arpeggiator on or off, use one of the following two procedures:
PROCEDURE 1
1) Select a Patch that utilizes the Arpeggiator, such as A11. Note the green
LED under "ARP/HAR" is lit, indicating the Arpeggiator is on.
2) Use the PARAMETER SELECT dial to select PATCH INC/DEC BY S1/S2.
3) Press PEDAL 4 to turn the Arpeggiator off.
4) Press PEDAL 4 again to toggle the Arpeggiator on or off.
PROCEDURE 2
1) Select a patch that utilizes the Arpeggiator, such as A11. Note the green
LED under "ARP/HAR" is lit, indicating the Arpeggiator is on.
2) Use the PARAMETER SELECT dial to select anything other than PATCH INC/DEC
BY S1/S2.
3) Press the S2 button on your GK-2A Pickup.
4) Press PEDAL 4 to turn the Arpeggiator off.
5) Press PEDAL 4 again to toggle the Arpeggiator on or off.