Key Shift adjusts, in half-steps, the pitch at which each Part is played. The pitch can be raised or lowered by up to an octave for each setting of +12 or -12. (If this parameter is set too high or low, it may not sound or it may sound strange depending on the original source sample.) Use the following procedure to Key Shift a Part:
1) Hold Part.
2) Use the VALUE buttons to select the desired Part.
3) Release the Part button.
4) Press SELECT twice until Part Param 2 lights up.
5) Press F2 to select Key Shift.
6) Use the VALUE buttons to change the pitch by half-steps.
7) Press PATCH to exit.
1) Hold Part.
2) Use the VALUE buttons to select the desired Part.
3) Release the Part button.
4) Press SELECT twice until Part Param 2 lights up.
5) Press F2 to select Key Shift.
6) Use the VALUE buttons to change the pitch by half-steps.
7) Press PATCH to exit.