The individual outputs of the JD-990 are assigned in Performance Mode. Use the
following procedure to assign the Part outputs of a Performance:
1) Press PERFORMANCE.
2) Press OUT followed by FX (F4).
3) CURSOR to "Output Assign" for the desired Part and use the VALUE DIAL to
select the desired output.
Note: When you assign a Patch to the direct outs, It will not have any effects
on it.
following procedure to assign the Part outputs of a Performance:
1) Press PERFORMANCE.
2) Press OUT followed by FX (F4).
3) CURSOR to "Output Assign" for the desired Part and use the VALUE DIAL to
select the desired output.
Note: When you assign a Patch to the direct outs, It will not have any effects
on it.