To bounce tracks with effects is very similar to bouncing tracks ...with one additional step in that you also route the FX RETURN to the tracks you are bouncing too. Bouncing tracks with effects is also known as PRINTING FX.
Step by Step:
- Make sure that the TR (TRACK FADER) mode indicator is lit.
- Hold down the Status button for the TRACK you want to bounce to.
- CONTINUE HOLDING THE STATUS BUTTON for the next few steps.) The INPUT ASSIGN screen will appear as you hold down the button.
You may want to Press the CLEAR button to clear any previous routing depending on your application. - Press the TRACK SELECT button for each of the TRACKS you wish to bounce or combine.
The TRACK SELECT buttons are the middle row of buttons above the channel faders.
The Screen will show a line drawn from the bottom of the screen (TRACK CHANNEL) to the middle row of numbers which is the RECORDING TRACK which is the tracks you are bouncing too.
You can now release holding the STATUS button, set your levels and arm the track for recording.
If you want to make additional routing, continue repeating all steps above except for STEP-3 which is to clear all routing.
To unselect a routing, you would do the same steps above by holding the STATUS button for the track you are routing too, and press the Input select button again which toggles between being routed and un-routed.