It's important to choose the appropriate Output Selection so it matches as close as possible to what the GT-10 is connected to. For example, if you have the GT-10 connected to a PA system, you would choose "LINE/PHONES". Use the following steps to set the Output Select:
1. Just below the main OUTPUT LEVEL knob, press the OUTPUT SELECT button.
2. Turn the VALUE dial to optimize your GT-10 for the device you're connecting to.
JC-120 - Roland JC-120 amp's input
SMALL AMP - Small or practice guitar amp's input
COMBO AMP - Combo amp's input
STACK AMP - Stack amp's input
JC-120 RETURN - The effects return jack on a JC-120
COMBO RETURN - The effects return jack of a combo amp
STACK RETURN - The effects return jack of a stack amp
LINE/PHONES - Headphones, or a mixer, recorder input or amp
3. Press the GT-10's EXIT button when you're finished.
4. Raise the GT-10's OUTPUT LEVEL knob.
5. Raise the volume of your amp or mixer to the desired level.
1. Just below the main OUTPUT LEVEL knob, press the OUTPUT SELECT button.
2. Turn the VALUE dial to optimize your GT-10 for the device you're connecting to.
JC-120 - Roland JC-120 amp's input
SMALL AMP - Small or practice guitar amp's input
COMBO AMP - Combo amp's input
STACK AMP - Stack amp's input
JC-120 RETURN - The effects return jack on a JC-120
COMBO RETURN - The effects return jack of a combo amp
STACK RETURN - The effects return jack of a stack amp
LINE/PHONES - Headphones, or a mixer, recorder input or amp
3. Press the GT-10's EXIT button when you're finished.
4. Raise the GT-10's OUTPUT LEVEL knob.
5. Raise the volume of your amp or mixer to the desired level.