The following procedure can be used to clear a patch:
(CAUTION: All USER information in the patch will be lost. Be sure to back up any information you wish to keep.)
1. Turn the PATCH/VALUE dial to select a patch you wish to initialize.
2. Press the WRITE button.
3. Press the Parameter right button until "Initialize" shows in the display.
Note: If you do not want to initialize the patch at this point press EXIT.
4. Press WRITE to initialize the patch. "Initializing" shows briefly in the display and then the RC-50 returns to the main patch menu.
Note: If you wish to initialize any of the preset patches, you must turn off "Preset Protect."
Refer to "Preset Protect" in this Knowledge base.
(CAUTION: All USER information in the patch will be lost. Be sure to back up any information you wish to keep.)
1. Turn the PATCH/VALUE dial to select a patch you wish to initialize.
2. Press the WRITE button.
3. Press the Parameter right button until "Initialize" shows in the display.
Note: If you do not want to initialize the patch at this point press EXIT.
4. Press WRITE to initialize the patch. "Initializing" shows briefly in the display and then the RC-50 returns to the main patch menu.
Note: If you wish to initialize any of the preset patches, you must turn off "Preset Protect."
Refer to "Preset Protect" in this Knowledge base.