Use the following steps to calibrate the EXP pedal on the GT-6:
- Hold down [PEDAL ASSIGN] while you switch on the power.
The following messages alternate in the display. - With the pedal completely released, press [WRITE].
The message “--- OK! ---” appears, and then the following messages alternate in the display.
* If you press [WRITE] when the pedal is not completely released, or when the pedal position (angle) is not correct, the message “--- Area Over! ---” appears in the display, and you are prevented from proceeding to the next step. If this occurs, readjust the pedal position. - With the pedal fully depressed, press [WRITE].
“--- OK! ---” appears, followed by "press [EXIT]."
* If you press [WRITE] when the pedal is not fully depressed, or when the pedal position (angle) is not correct, the message “--- Area Over! ---” appears in the display, and you are prevented from proceeding to the next step. If this occurs, readjust the pedal position. - Press [EXIT].
After the message “Checking data please wait...” has been displayed, you'll be returned to the Play screen.