"Recover" copies the project from the CD to the drive (partition) that is currently loaded. To recover a backup, follow these steps:
- Insert the first CD Backup into your CD-R/RW drive.
- Navigate to the Project List;
- For the VS-2480: Press the PROJECT button.
- For the VS-2400CD: Hold the SHIFT button and then press F1 (Project).
- Press CURSOR down to scroll through the Project List until the selector box is around the the CD-RW drive. It may be labeled as SCSI or ATAPI
- Press F6(List).- "Change Current Drive, Sure?", appears in the display.
- Press ENTER(YES) -"Store Current?" appears.
- Press the ENTER(YES).
- Cursor to the desired project and press F6 to mark it.
- Press PAGE until "Recovr" is shown above F2.
- Press F2 (Recovr)- PROJECT RECOVER screen.
- Cursor down to the CD Speed box and highest value available.
You can choose a slower speed if desired. - Press F5(OK) to begin the recover process.
"CD-R Recover, Sure?" appears in the display. - Press ENTER(YES) to continue.
"Store Current?" appears on the display. - Press ENTER(YES) to continue.
Note: If the backup is larger than a single disk, the VS-2480/2400 asks for additional disks as needed.