Performance and Patch data on the JV-80, JV-90, and JV-1000 can be recorded
into your MIDI sequencer by performing a system exclusive bulk dump. Make sure
that the MIDI OUT port on your keyboard is connected to the MIDI IN port on
your sequencer or MIDI interface. Use the following procedure to record a
system exclusive bulk dump:
1) Press WRITE
2) Cursor to [BULK] and press ENTER.
3) Select [Internal, Card or Temporary] and press ENTER
4) Select [Performance, Patch, Rhythm, or All].
5) Make sure that your sequencer is set to record system exclusive messages
and begin recording.
6) Press ENTER.
NOTE: The display will indicate when the bulk dump is finished (depending on
the amount of data sent, it can take as many as 20 measures of a song recording
in 4/4 time at a tempo of 120 beats per minute to store the data.
into your MIDI sequencer by performing a system exclusive bulk dump. Make sure
that the MIDI OUT port on your keyboard is connected to the MIDI IN port on
your sequencer or MIDI interface. Use the following procedure to record a
system exclusive bulk dump:
1) Press WRITE
2) Cursor to [BULK] and press ENTER.
3) Select [Internal, Card or Temporary] and press ENTER
4) Select [Performance, Patch, Rhythm, or All].
5) Make sure that your sequencer is set to record system exclusive messages
and begin recording.
6) Press ENTER.
NOTE: The display will indicate when the bulk dump is finished (depending on
the amount of data sent, it can take as many as 20 measures of a song recording
in 4/4 time at a tempo of 120 beats per minute to store the data.