VG-88: How do I restore the factory settings?

You can perform a factory reset on the VG-88 to initialize all settings or only a specified range of patch data or system settings.

The following types of data can be initialized:

• SYSTEM: All system parameters
• #1-1–#25-4: The setting contents of patches 1-1–25-4

Use the following procedure:

1. Turn off the power.
2. While holding [PAGE ◀] and [PAGE ▶] down, switch on the unit.
   A display will appear, allowing you to specify the area of data you wish to initialize.
   
3. Move the cursor to “START” with [CURSOR], then use the VALUE dial to get the display to show the data that is the beginning point of the initialization.
4. Move the cursor to “END” with [CURSOR], then get the display to show the ending point of the initialization, also using the VALUE dial.
5. Press [WRITE].
   The display will indicate “ARE YOU SURE?”

6. If you wish to initialize, press [WRITE]. The specified area of data will be initialized.
   The VG-88 will then be in its normal power-on state.

   If you decide not to initialize the settings, press [EXIT]. Initialization will be canceled, and the normal power-on display will appear.