Use the following procedure to edit a Patch:
1. Press PATCH.
2. Notice that there are four Tone Switch buttons under the display. Any tone(s) that are lit are active in the selected patch. To enable or disable a tone, press its Tone Switch button so it is lit or not lit.
3. Make sure that the Tone Select button is lit to correspond to an active Tone; otherwise, you will not be able to hear any edits that you make.
4. Press PARAMETERyou are now in Edit Mode.
5. Press WAVE (written in orange); this will show you the waveform being used for the selected tone. Notice the arrow in the display; this indicates that you can access more wave parameters by using CURSOR UP or DOWN.
6. All other patch parameters are accessed by pressing a corresponding button (i.e. COMMON, EFFECTS, CONTROL, etc).
7. You can press the PALETTE button at any time to view the selected parameter setting for all four tones simultaneously.
1. Press PATCH.
2. Notice that there are four Tone Switch buttons under the display. Any tone(s) that are lit are active in the selected patch. To enable or disable a tone, press its Tone Switch button so it is lit or not lit.
3. Make sure that the Tone Select button is lit to correspond to an active Tone; otherwise, you will not be able to hear any edits that you make.
4. Press PARAMETERyou are now in Edit Mode.
5. Press WAVE (written in orange); this will show you the waveform being used for the selected tone. Notice the arrow in the display; this indicates that you can access more wave parameters by using CURSOR UP or DOWN.
6. All other patch parameters are accessed by pressing a corresponding button (i.e. COMMON, EFFECTS, CONTROL, etc).
7. You can press the PALETTE button at any time to view the selected parameter setting for all four tones simultaneously.