A Bulk Dump or Bulk Load creates or re-loads a backup for archiving internal data. Use the following procedure to perform a Bulk Dump or Bulk Load:
1. Press EDIT.
2. Press F5 [System].
3. Use the CURSORS and VALUE dial to set the Unit Number to "17" and Exclusive RX to "On."
NOTE: The value of the Unit Number can vary, however it is important that it remain constant when transmitting or receiving system exclusive data.
The D-70 must now be set to Extended Product Mode.
4. Power off.
5. While holding NUMBER 5 turn the unit on.
For Bulk Dump:
6a. Select F1 [Dump All].
7a. Begin recording on your sequencer, then press ENTER on the D-70.
8a. When finished, power the D-70 off and on.
For Bulk Load:
6b. Select F2 [Load All], then press Enter.
7b. Play the data in from the sequencer.
8b. After loading, power the D-70 off and on.
1. Press EDIT.
2. Press F5 [System].
3. Use the CURSORS and VALUE dial to set the Unit Number to "17" and Exclusive RX to "On."
NOTE: The value of the Unit Number can vary, however it is important that it remain constant when transmitting or receiving system exclusive data.
The D-70 must now be set to Extended Product Mode.
4. Power off.
5. While holding NUMBER 5 turn the unit on.
For Bulk Dump:
6a. Select F1 [Dump All].
7a. Begin recording on your sequencer, then press ENTER on the D-70.
8a. When finished, power the D-70 off and on.
For Bulk Load:
6b. Select F2 [Load All], then press Enter.
7b. Play the data in from the sequencer.
8b. After loading, power the D-70 off and on.