There are some instances where it may be desired to have the GT-8 connected to the Effects SEND and RETURN loop on an Amplifier. Use the following connection set up for this application:
1. Turn the volume down on the amp and make sure the GT-8's power is OFF.
2. Connect one end of the guitar cable to the SEND on the amplifier, and the opposite end to the INPUT on the GT-8.
3. Connect one end of another guitar cable to the RETURN of the amplifier, and the opposite end to the OUTPUT L(MONO) of the GT-8.
4. Now connect the guitar to the front INPUT on the Amp.
5. Turn ON the GT-8.
6. Adjust volume on both the Amp and the GT-8 as desired.
Note: It may also be necessary to change the "Output Select" on the GT-8 accordingly - i.e. JC-120, COMBO RETURN, STACK RETURN. To change the output select, press OUTPUT SELECT, then turn the VALUE dial to make the desired selection.
1. Turn the volume down on the amp and make sure the GT-8's power is OFF.
2. Connect one end of the guitar cable to the SEND on the amplifier, and the opposite end to the INPUT on the GT-8.
3. Connect one end of another guitar cable to the RETURN of the amplifier, and the opposite end to the OUTPUT L(MONO) of the GT-8.
4. Now connect the guitar to the front INPUT on the Amp.
5. Turn ON the GT-8.
6. Adjust volume on both the Amp and the GT-8 as desired.
Note: It may also be necessary to change the "Output Select" on the GT-8 accordingly - i.e. JC-120, COMBO RETURN, STACK RETURN. To change the output select, press OUTPUT SELECT, then turn the VALUE dial to make the desired selection.