The U-220 stores Timbres in Patch memories. Use the following procedure to save a Timbre into a Patch:
1. Call up the Timbre in the desired Part.
2. Press EDIT.
3. CURSOR to Patch and press ENTER.
4. CURSOR to Part and press ENTER.
5. CURSOR to Timbre and press ENTER.
6. VALUE up or down to locate the Timbre.
7. Press DATA.
8. CURSOR to Write and press ENTER.
9. CURSOR to Patch and press ENTER.
10. Select the destination of the Patch by pressing the right CURSOR button.
11. Use the VALUE buttons to select the desired location and press ENTER.
12. Press VALUE ^ to exit.
1. Call up the Timbre in the desired Part.
2. Press EDIT.
3. CURSOR to Patch and press ENTER.
4. CURSOR to Part and press ENTER.
5. CURSOR to Timbre and press ENTER.
6. VALUE up or down to locate the Timbre.
7. Press DATA.
8. CURSOR to Write and press ENTER.
9. CURSOR to Patch and press ENTER.
10. Select the destination of the Patch by pressing the right CURSOR button.
11. Use the VALUE buttons to select the desired location and press ENTER.
12. Press VALUE ^ to exit.