Along with the variety of different wah types, the PW-10 also has 8 distortion models and a built-in noise suppressor. Use the following steps to select different distortion and noise suppressor settings, and then store them into memory:
- Turn off the PW-10's power and turn down the volume on your guitar amp.
- Turn the TYPE knob to select "ADVANCED."
- Press and hold the MANUAL/MEMORY button and switch on the PW-10's power.
Note: If using battery power, connect the guitar cable to the INPUT of the PW-10. If using the BOSS PSA series power supply, connect it to the DC input on the PW-10.
Once the power is on, the On/OFF indicator will flash briefly, then light up solid. - Release MANUAL/MEMORY.
- Turn up the volume on your guitar amp.
- Turn the TYPE knob to select one of the 8 DRIVE types.
Tip: You can find a chart with the different DRIVE types printed on the underside of the PW-10. - Turn the WAH RANGE knob to adjust the Noise Suppressor threshold level.
- Turning the knob clockwise increases the noise suppression. - When finished, press the MANUAL/MEMORY button once. (The MEMORY indicator will flash).
- Turn the DRIVE knob to adjust the volume level as desired.
- When finished, press the MANUAL/MEMORY button.
- The MEMORY indicator will flash and the settings are stored into the Manual location.