Use the following procedure to Bulk Load the Set Up MIDI data back into the RD-300SX:
1. Connect the RD-300SX to an external sequencer.
2. Press EDIT so it is NOT lit.
3. Transmit (play back) the Bulk Load data from the external sequencer.
NOTE: After reception of the Bulk Dump Setup data, the RD-300SX will begin writing the data to the internal memory. Never turn off the RD-300SX while this data is being written.
1. Connect the RD-300SX to an external sequencer.
2. Press EDIT so it is NOT lit.
3. Transmit (play back) the Bulk Load data from the external sequencer.
NOTE: After reception of the Bulk Dump Setup data, the RD-300SX will begin writing the data to the internal memory. Never turn off the RD-300SX while this data is being written.