It's important to choose the appropriate Output Selection so it matches as close as possible to what the GT-100 is connected to. For example, if you have the GT-100 connected to a PA system, you would choose "LINE/PHONES." Use the following steps to set the Output Select.
- Press SYSTEM.
- Turn Knob 4 counter-clockwise until "Output Select" is highlighted.
- Turn Knob 8 to optimize your GT-100 for the device you're connecting it to.
- JC-120
- SMALL AMP
- COMBO AMP
- STACK AMP
- JC-120 RETURN
- COMBO RETURN
- STACK RETURN
- LINE/PHONES
- Press EXIT when you are finished. The new setting is saved automatically.
- Turn the GT-100's OUTPUT LEVEL knob clockwise.
- Raise the volume of your amp or mixer to the desired level.
NOTE: The SP Type parameter is valid only if the Output Select setting is set to “LINE/PHONES.”