To use the Patches on the SO-PCM1 series card you must load the them into
memory: Use the following procedure:
1) Press UTILITY.
2) Press F4 (CARD).
3) Press F5 (Ld PRM).
4) Set the source to PCM CARD.
5) RIGHT CURSOR to Number and Use the VALUE dial to select a Patch.
6) Press F6 (EXECUTE).
7) Press EXIT.
The Patch is now in temporary memory. You can play and edit the Patch but you
must save it to internal memory or to a card memory location to keep the Patch
available:
1) Press UTILITY.
2) Press F1 (WRITE).
3) Use the VALUE dial to select a destination for your Patch.
4) Press F6 (EXECUTE).
5) If Write Protect is on, use the VALUE dial to set it to OFF and press EXIT.
6) Press F6 (EXECUTE) again to complete the operation.
memory: Use the following procedure:
1) Press UTILITY.
2) Press F4 (CARD).
3) Press F5 (Ld PRM).
4) Set the source to PCM CARD.
5) RIGHT CURSOR to Number and Use the VALUE dial to select a Patch.
6) Press F6 (EXECUTE).
7) Press EXIT.
The Patch is now in temporary memory. You can play and edit the Patch but you
must save it to internal memory or to a card memory location to keep the Patch
available:
1) Press UTILITY.
2) Press F1 (WRITE).
3) Use the VALUE dial to select a destination for your Patch.
4) Press F6 (EXECUTE).
5) If Write Protect is on, use the VALUE dial to set it to OFF and press EXIT.
6) Press F6 (EXECUTE) again to complete the operation.