This operation cuts playback data from the specified area. This is procedure effectively removes the specified data and places the separated data together.
Use the following procedure to track cut:
- Hold SHIFT and press F2[TRACK].
- Press F1 so that "Track" is displayed.
- Press F6[Cut].
NOTE: If "Cut" does not appear in F6, first press PAGE until "Cut" is displayed and then press F6[Cut]. - Press F1[SelTr].
- Press the STATUS button(s) for the track(s) you wish to cut. The button indicator lights red.
- Press F1[Back].
- Press the UP, DOWN, LEFT and RIGHT CURSOR buttons to move the cursor.
Set each of your values for your start and end times with the TIME/VALUE dial.
- START (Start Point): Specifies the starting time of the segment you wish to cut.
- END (End Point) : Specifies the ending of the segment you wish to cut.
- ALL V.Tracks : Normally, data can be cut from the tracks that are audible. If you wish the same segment to be cut from all tracks, set this to "On."
- Press F4[Exec]. This executes the Track Cut.
- When Track Cut is completed correctly, "Complete" appears in the display.
- Press and hold the SHIFT button.
- While holding the SHIFT button, press the ZERO (STORE) button.
- Press ENTER to save the song project.
- Press PLAY[DISPLAY] to return to the Play condition.