There are two types of effects: Insert effects and Loop (send/return) effects. Insert effects replace the original dry signal with 100% effect, while loop effects are only sending a portion of the original signal to the effects. Insert effects are similar to taking a guitar, plugging it into a "stomp box", and then plugging the output of the box into the recorder. Loop effects require sending a portion of the signal to the effects processor, adding the effect, and then returning it back to the recorder. This procedure will add reverb to a recording on track 1.
1. Hold down SHIFT and press the F3 (EFFECT) button.
2. Press F1 (FX1) and then press it again to select PATCH.
3. With the TIME/VALUE dial, highlight P047 RV:Soft Amb. and press F5 (SELECT) to select it as FX1.
4. Press the TR 1-12 button to set up the faders for the track mixer.
5. Press the CH EDIT button (above TRACK STATUS) for Track 1.
6. CURSOR to the AUX 1 box and highlight the dB value in that box.
7. With the TIME/VALUE dial, change that value from "negative infinity" to at least -5 dB (the higher the value, the more effect).
8. Press the AUX1-8/FX1-4 button (above IN1-12).
9. Raise the fader for FX1 RTN to 0 dB. Press HOME (DISPLAY) to return to the main screen. Upon playback of the song, reverb is heard on track 1.
Note: To adjust the amount of the reverb on Track 1, go to the CH EDIT screen for that track and change the dB value in AUX 1.
1. Hold down SHIFT and press the F3 (EFFECT) button.
2. Press F1 (FX1) and then press it again to select PATCH.
3. With the TIME/VALUE dial, highlight P047 RV:Soft Amb. and press F5 (SELECT) to select it as FX1.
4. Press the TR 1-12 button to set up the faders for the track mixer.
5. Press the CH EDIT button (above TRACK STATUS) for Track 1.
6. CURSOR to the AUX 1 box and highlight the dB value in that box.
7. With the TIME/VALUE dial, change that value from "negative infinity" to at least -5 dB (the higher the value, the more effect).
8. Press the AUX1-8/FX1-4 button (above IN1-12).
9. Raise the fader for FX1 RTN to 0 dB. Press HOME (DISPLAY) to return to the main screen. Upon playback of the song, reverb is heard on track 1.
Note: To adjust the amount of the reverb on Track 1, go to the CH EDIT screen for that track and change the dB value in AUX 1.