Use the following steps to calibrate the on-board EXP pedal on the GT-10 or GT-10B:
1. Press SYSTEM.
2. Press cursor (>) right to select PEDAL CALIBRATION.
3. Press CATEGORY/ENTER.
4. Heel back on the EXP pedal until it stops.
5. Press CATEGORY/ENTER.
6. Press the EXP all the way toe-forward.
7. Press CATEGORY/ENTER.
8. Turn the VALUE dial to set the desired threshold for the toe-end switch (1-16). A lower value allows for the switch to be activated with minimal pressure. More force is needed for higher values.
9. Press EXIT when you're finished.
1. Press SYSTEM.
2. Press cursor (>) right to select PEDAL CALIBRATION.
3. Press CATEGORY/ENTER.
4. Heel back on the EXP pedal until it stops.
5. Press CATEGORY/ENTER.
6. Press the EXP all the way toe-forward.
7. Press CATEGORY/ENTER.
8. Turn the VALUE dial to set the desired threshold for the toe-end switch (1-16). A lower value allows for the switch to be activated with minimal pressure. More force is needed for higher values.
9. Press EXIT when you're finished.