You can use project IMPORT to restore song backup and archive data from the following VS recorders:
- VS-880/880EX
- VS-890
- VSR-880
- VS-1680
- VS-1880/1824/1824CD
- VS-2400CD/2480/2480CD
When you import a song from an earlier V-Studio, the VS-2000CD converts it into a VS-2000CD project. You can recover backed-up song data from a CD. After the VS-2000CD imports the song, it’s loaded as the current project. The following steps will guide you through this procedure:
- Insert the CD containing the backed-up song data into your CD-R/RW drive.
- Hold down SHIFT and press F1.
- Use the CURSOR buttons to select the ATAPI CD drive containing the song data--the selector box should be surrounding the ATAPI drive on the bottom of the project list.
- Press F6 (LIST).
- Press ENTER/YES to change drives. The VS-2000CD will load the contents of the CD and display the songs beneath the ATAPI drive.
- Use the CURSOR buttons to select the song you would like to import and then press F6 to mark the song.
- Select the drive to which you want to import the song.
- If “IMPORT” is not visible above F3, press PAGE until it is.
- Press F3 (IMPORT)—the PROJECT IMPORT screen appears.
- Select the desired Recording Mode for the imported song.
- If the song has more than 18 tracks, the Import Track parameter allows you to select the set of tracks you’d like to import.
- Set Erase All Projects as desired. You can select:
Off—to add the imported song to projects already on the selected partition.
On—to wipe all other projects from the selected partition during importing. - Set CD Speed to the maximum setting. If the import fails, lower the speed.
- Press F5 (OK) to import the marked songs—the VS-2000 asks if you’re sure.
- Press ENTER/YES to start importing.