The STUDIO-CAPTURE offers four independent Direct Monitor Mixers for creating monitor mixes. Each Direct Monitor Mixer (MIX A, MIX B, MIX C and MIX D) is a stereo mixer to specify the balance by adjusting the level and pan individually. Each mix can be routed to any of the analog outputs. This is perfect for sending custom monitor mixes to headphones, speakers or recording devices.
Note: If the STUDIO-CAPTURE’s sampling frequency is set to 192 kHz, only monitor mixer “A” can be used. The other monitor mixers cannot be used. If using other monitor mixes is desired, set the sample rate to 96kHz or lower:
- If using audio software, change the sample rate of the audio project you're working on. The STUDIO-CAPTURE will automatically change it's sample rate to match the audio project. Check the documentation of the audio software or contact the software manufacturer for these instructions.
-
If using the STUDIO-CAPTURE without software, change this in the STUDIO-CAPTURE itself:
https://www.roland.com/us/support/knowledge_base/360004896691/
The following example will guide through setting up a single stereo monitor mix that will be send identical signals out of LINE OUT 1L,2R jacks, PHONES 1 jack, PHONES 2 jack and MONITOR OUT 1L, 2R jacks. However these steps are similar for creating additional mixes (e.g. MIX B, MIX C or MIX D) and selecting their output destinations in the PATCHBAY.
-
Connect monitor speakers to the LINE OUT 1L,2R jacks or MONITOR OUT 1L, 2R jacks.
Or connect headphones to PHONES 1 jack and/or PHONES 2 jack. -
Turn up the volume on your monitor speakers and/or PHONES LEVEL knobs on the STUDIO-CAPTURE.
Note: Be careful not to turn up the volume too much--as this may cause feedback, damage the speakers/headphones or possibly damage to your hearing. -
Press and hold the VALUE knob (MENU button) for a few seconds. The System screen appears.
-
Use the arrow buttons to select "PATCHBAY" and then press the right cursor button.
NOTE: The patch bay is not available when operating at a sampling rate of 192 kHz. -
Use the arrow buttons to select "OUTPUT 1-2” and then turn the VALUE knob to select "MIX A”.
-
Press the DISPLAY button twice to return to the main screen and then press the arrow buttons to access the MIX A screen.
-
Use the arrow buttons to select a desire parameter menu:
-
You can also turn the [DIRECT MONITOR] knob to adjust the overall level of all direct monitoring.
-
Use the cursor buttons to select the MIX A MASTER screen.
-
Use the cursor buttons to move the cursor to both left and right output level faders and then use the VALUE dial to raise or lower them to a desired level.
-
Press the MIX SEL button to return to the mixer view.