You can use project IMPORT to restore song backup and archive data from the following VS recorders:
• VS-880/880EX
• VS-890
• VSR-880
• VS-1680
• VS-1880/1824/1824CD
• VS-2400CD/2480/2480CD
When you import a song from an earlier V-Studio, the VS-2480 converts it into a VS-2480 project. You can recover backed-up song data from a CD. After the VS-2480 imports the song, it’s loaded as the current project. The following steps will guide you through this procedure:
-
Insert the CD containing the backed-up song data into your CD-R/RW drive.
-
Press the PROJECT button.
-
Use the CURSOR buttons to select the ATAPI CD drive containing the song data--the selector box should be surrounding the ATAPI drive on the bottom of the project list.
-
Press F6 (LIST).
-
Press ENTER/YES to change drives. The VS-2480 will load the contents of the CD and display the songs beneath the ATAPI drive.
-
Use the CURSOR buttons to select the song you would like to import and then press F6 to mark the song.
-
Select the drive to which you want to import the song.
-
If “IMPORT” is not visible above F3, press PAGE until it is.
-
Press F3 (IMPORT)—the PROJECT IMPORT screen appears.
-
Select the desired Recording Mode for the imported song.
-
If the song has more than 18 tracks, the Import Track parameter allows you to select the set of tracks you’d like to import.
-
Set Erase All Projects as desired. You can select:
• Off—to add the imported song to projects already on the selected partition.
• On—to wipe all other projects from the selected partition during importing.
-
Set CD Speed to the maximum setting. If the import fails, lower the speed.
-
Press F5 (OK) to import the marked songs—the VS-2480 asks if you’re sure.
-
Press ENTER/YES to start importing.