BR-80, MICRO BR: Recording Audio in Sonar X3, X2, X1 and Music Creator 6

The following article will guide through setting up the BR-80 to record audio into Sonar X3, X2, X1 and Music Creator 6.

Note: The BR-80 driver must be installed and setup prior to following the instructions below. If you have not installed the driver, you can download this from the link below:
BR-80 Downloads

First, be sure that the BR-80's USB mode is set to AUDIO:

1. Press the MENU button. 
2. Cursor to "Function" and then press ENTER. 
3. Cursor to "USB" and then press ENTER. 
4. Use the dial to specify "AUDIO" and then press ENTER. 
   A message will appear: "Please restart to change the USB mode." 
5. Press ENTER.
6. Power off the BR-80 and then turn the power back on. Your BR-80 is now ready to be synced with the eBand software.

Next, the following two videos will guide through setting up an audio driver (such as the BR-80) in Sonar or Music Creator 6 and then recording a track:

Driver Setup (ASIO):

Recording an Audio Track: