1. Connect a MIDI cable from the ES-8’s MIDI Out/THRU jack to the MIDI
IN of the receiving device.
2. Press EDIT.
3. Press the Page Left/Right buttons to get to the CTL/EXP category.
4. Press ENTER.
5. Page Left/Right to the ASSIGN number you want to use (1 thru 12).
6. Press ENTER.
7. Press + to turn the Assign’s On/Off switch to ON.
8. Page to the Assign Source setting (Src).
9. Press -/+ to get to the Assign source you want to set up (eg.” CTL 1-6,
EXP 1-2, etc.)
10. Press Page right to choose whether the Assign will be in Momentary or
Toggle Mode, if applicable.
11. Press Page right to get to the Category parameter (Cate).
12. Press -/+ to choose the Assign’s Category type.
13. Press Page right to choose the MIDI channel.
14. Press -/+ to select desired channel (1 to 16).
15. Press Page right to choose the MIDI CC message.
16. Press -/+ to select desired CC number (1 to 127).
17. Press Page right to configure Min/Max Range page.
18. Press -/+ to select desired Min/Max values (Typically 0 and 127).
19. Press Page right to configure Active Range page.
20. Press -/+ to select desired Min/Max values (Typically 0 and 127).