日本語 Português do Brasil 简体中文

See more

ES-8: Send MIDI CC Messages Using Assigns

  • Updated
  1. Connect a MIDI cable from the ES-8’s MIDI Out/THRU jack to the MIDI IN of the receiving device.
  2. Press EDIT.
  3. Press the Page Left/Right buttons to get to the CTL/EXP category.
  4. Press ENTER.
  5. Page Left/Right to the ASSIGN number you want to use (1 thru 12).
  6. Press ENTER.
  7. Press + to turn the Assign’s On/Off switch to ON.
  8. Page to the Assign Source setting (Src).
  9. Press -/+ to get to the Assign source you want to set up (eg.” CTL 1-6, EXP 1-2, etc.)
  10. Press Page right to choose whether the Assign will be in Momentary or Toggle Mode, if applicable.
  11. Press Page right to get to the Category parameter (Cate).
  12. Press -/+ to choose the Assign's Category type.
  13. Press Page right to choose the MIDI channel.
  14. Press -/+ to select desired channel (1 to 16).
  15. Press Page right to choose the MIDI CC message.
  16. Press -/+ to select desired CC number (1 to 127).
  17. Press Page right to configure Min/Max Range page.
  18. Press -/+ to select desired Min/Max values (Typically 0 and 127).
  19. Press Page right to configure Active Range page.
  20. Press -/+ to select desired Min/Max values (Typically 0 and 127).
Was this article helpful?
1 out of 6 found this helpful

Need more help? Go Backstage

Return to top

Related articles