(NOTE: you will need to use at least two presets.)
- Connect a TRS 1/4" cable from the CTL 1/2 jack, under the EXT CTL section of the of the ES-8's back panel, to the footswitch jack on the back of your amp.
- For the first ES-8 preset that will represent the amp channel one, CTL1/2's setting should be "OFF".
- To confirm this, press the EDIT button, then use the Page Left/Right buttons to get to the PATCH category.
- Press ENTER, then page over to the CTL ON/OFF assign screen to confirm settings.
- To set up the second preset for amp channel two, press DISPLAY/EXIT twice.
- Press footswitch to select the second preset you wish to use.
- Press ENTER.
If necessary, use the Page Left/Right buttons to get to the PATCH category. - Press ENTER, then page over to the CTL ON/OFF assign screen.
- Press ENTER.
- Use the Page Left/Right buttons to get to the CTL 1 assign number.
- Use the +/- buttons to turn CTL 1 "ON".
- Tap WRITE three times to save the patch.
- Selecting preset one or two should now change amp channels.