You can assign a function to a footswitch (sold separately: FS-5U, FS-5L, FS-6, FS-7) or expression pedal (sold separately: Roland EV-5 etc.) connected to the CTL 1,2/EXP jack.
1. Press the [EDIT] button.
2. Use the UP/DOWN Arrow buttons to select “CONTROL,” and then press the
[EDIT] button.
3. Use the UP/DOWN Arrow buttons to select a parameter, and use the [TIME/
VALUE] knob to edit the value.
To determine how the footswitch and assignment will work, choose from the following settings:
PREF - PATCH Different settings can be made for each patch.
SYSTEM The same settings are shared by all patches.
FUNC - Specifies the function of the footswitches connected to the CTL 1,2/EXP jack
MODE - MOMENT The switch is normally off (minimum value), and turns on
(maximum value) only while you hold it down.
TOGGLE The switch alternately switches off (minimum value) and on
(maximum value) each time you press it.
CTL1 AND CTL2 FUNCTIONS THAT CAN BE ASSIGNED
OFF - No function is assigned
TAP - Use the switch for tap input.
HOLD - Repeats the delay sound while you hold down the switch.
WARP - Simultaneously controls the delay sound’s feedback level and volume to produce a totally unreal delay.
TWIST - A new type of delay that produces an aggressive, spinning sensation.
MOMENTARY - Outputs the delay sound only while you hold down the switch.
ROLL 1/2 - Cuts the delay time to 1/2 the setting only while you hold down the switch.
ROLL 1/4 - Cuts the delay time to 1/4 the setting only while you hold down the switch.
ROLL 1/8 - Cuts the delay time to 1/8 the setting only while you hold down the switch.
FADE IN/FADE OUT - Fades-in/-out the delay sound.
EFFECT SW - Turns the effect on/off.
BANK UP/BANK DOWN - Change banks.
LOOP ON/Off - Enter/Exit the Phrase
LOOP CLEAR - Erase the phrase