The INTEGRA-7 Version 2 Editor can be used as a VST3 or AU plug-in within a DAW, allowing you to edit Studio Sets, Tones, and other parameters directly from your DAW project. After installing the editor, launch it in your DAW and configure the following settings to communicate with the INTEGRA-7.
Download the latest INTEGRA-7 Version 2 Editor and USB Driver from the Downloads page below.
https://www.roland.com/global/support/by_product/integra-7/updates_drivers/
Note: The procedure for adding a VST3 or AU plug-in varies depending on the DAW you are using. Refer to the documentation for your DAW for detailed instructions.
- Launch the INTEGRA-7 V2 Editor in your DAW.
- Click UTILITY in the upper-right corner of the editor window.
- Select DEVICE from the menu on the left side of the editor window.
- Set both Input Device and Output Device to INTEGRA-7 CTRL, and then click OK.
- Click READ in the upper-right corner of the editor window to synchronize the editor with the INTEGRA-7.
The synchronization process takes approximately 15–20 seconds. When synchronization is complete, the editor loads the current settings from the INTEGRA-7 and is ready for editing.
Note: When connecting the INTEGRA-7 to a computer via USB, use a USB cable that supports data transfer. Charging-only USB cables cannot be used for USB communication.