ES-8: Edit and Save Patch Settings in Memory Mode Using Footswitches (Quick Edit Mode)

Here’s how you can turn the effect loops on/off and save the settings by operating only the switches.

1. Recall the patch that you want to edit.
2. Hold down the [MEMORY/MANUAL] switch for two seconds or longer.
   The MEMORY/MANUAL indicator blinks blue and the ES-8 will then be in memory edit mode.
3. Use number switches [1]–[8] to turn each effect loop on or off.
4. Press the [MEMORY/MANUAL] switch.
5. Use the [BANK Up] [BANK Down] switches and number switches [1]–[8] to select the save-destination.
6. Press the [MEMORY/MANUAL] switch.
   If you decide to cancel, press the MUTE switch.
   When the settings are saved, the MEMORY/MANUAL indicator changes to steadily lit blue.