CABLING SETUP:
1. Connect the 1/4" TRS cable from your Expression pedal to either of the
two CTL/EXP IN jacks.
2. Then connect a MIDI cable from the ES-8's MIDI out jack to the MIDI input of the device you
wish to control.
ES-8 SETUP STEPS:
1. Connect a MIDI cable from the ES-8’s MIDI Out/THRU jack to the MIDI
IN of the receiving device.
2. Press EDIT.
3. Press the Page Left/Right buttons to get to the CTL/EXP category.
4. Press ENTER.
5. Page Left/Right to the ASSIGN number you want to use (1 thru 12).
6. Press ENTER.
7. Press + to turn the Assign’s On/Off switch to ON.
8. Page to the Assign Source setting (Src).
9. Press -/+ to get to the Assign source: EXP1, EXP2.
10. Press Page right to get to the Category parameter (Cate).
11. Press -/+ to choose the Assign’s Category type: MIDI.
12. Press Page right to choose the MIDI channel.
13. Press -/+ to select desired channel (1 to 16).
14. Press Page right to choose the MIDI CC message.
15. Press -/+ to select desired CC number (1 to 127).
16. Press Page right to configure Min/Max Range page.
17. Press -/+ to select desired Min/Max values (Typically 0 and 127).
18. Press Page right to configure Active Range page.
19. Press -/+ to select desired Min/Max values (Typically 0 and 127).
20. Configure any Control/Expression assignments necessary on the receiving device.