It's possible to load your own samples (sounds) into the TD-50. Once they have been imported, you can then assign them to the various pads to be triggered. Here's how to import a sample.
Before attempting to import samples, they must conform to the following criteria:
Format - .wav
Bit rate - 16 or 24 bit
Sampling Frequency - 44.1kHz
Length of each file: Maximum 180 seconds
For more details and troubleshooting regarding file compatibility, please refer to the following article in our Knowledge Base:
https://www.rolandus.com/support/knowledge_base/218241663
1. Insert the SD card that contains the samples into the card slot on the left side panel of the TD-50.
2. Press and hold the SHIFT button and then press the SETUP (USER SAMPLE) button.
3. Press F1 (IMPORT).
4. Use the cursor buttons to highlight the User sample that you want to import.
Tip: You can preview each sample by pressing the F4 button after highlighting it.
5. Press F5 (SELECT).
6. Turn the dial or press the + or - buttons to select the desired [empty] destination number for the sample to be imported to. There are a total of 500 locations available.
Note: If you attempt to import into a location that already has a sample assigned, "User Sample Exists" will appear and you'll need to choose a different location.
7. Press F5 (IMPORT).
8. Cursor right to highlight "OK."
9. Press ENTER.