Parameters added to patch mode PATCH SETUP
MEMO: PWM LFO: This dedicated LFO is a triangle wave that modulates the pulse width of all 3
oscillators (OSC 1–3).
* If a waveform other than pulse wave is selected, modulation is not applied.
1. Press the [COMP] button and [PLAY] button to make them light.
* If you decide to cancel, press the [COMP] button and [PLAY] button once again to make them go dark.
2. Use the [1]–[8] buttons to select a parameter, and use the [VALUE] knob to edit the parameter’s value. The display indicates the value
Parameters added Version 1.10
[7] PWM LFO rate 0–127 Adjusts the rate of the PWM LFO.
[8] PWM LFO depth 0–127 Adjusts the depth of the PWM LFO.
* To save the edited settings, perform the Patch Write operation.
Newly added parameters allow you to specify fine tune and key follow for the voltage
that is input to the CV INPUT jack.
[15] CV Fine Tune 0–255 Finely adjusts the pitch relative to the voltage that is input to the
CV INPUT jack.
[16] CV Key Follow 0–255 Adjusts the width of pitch change relative to the voltage that is
input to the CV INPUT jack.
Tips
Adjusting the CV INPUT jack’s key follow setting will cause the tuning to change slightly.
For this reason,you should adjust key follow first, and then use fine tune to specify the
overall pitch.
* There is no need to execute the Write operation. CV Fine Tune and CV Key Follow are
saved as settings for the entire system.