Limitations when using the 192 kHz setting
If the STUDIO-CAPTURE’s sampling frequency is set to 192 kHz, its operation will be limited as listed below.
- Only monitor mixer “A” can be used. The other monitor mixers cannot be used.
- Only the INPUT 1–8 jacks and the LINE OUT 1L, 2R. 3, 4 jacks can be used. The other INPUT and LINE OUT jacks cannot be used.
- The COAXIAL OUT (9/10), IN (15/16) jacks cannot be used.
- Reverb will be unavailable for monitor mixer “A.”
- Patch bay settings cannot be changed.
- The output settings will be fixed at the four channels OUT 1-2: MONITOR A and OUT 3-4: WAVE OUT 3-4. The inputs will be fixed at INPUT 1–4.
To alleviate this, use a sample rate of 96kHz or smaller.
- If using audio software, change the sample rate of the audio project you're working on. The STUDIO-CAPTURE will automatically change it's sample rate to match the audio project. Check the documentation of the audio software or contact the software manufacturer for these instructions.
- If using the STUDIO-CAPTURE without software, change this in the STUDIO-CAPTURE itself:
https://www.roland.com/us/support/knowledge_base/360004896691/