Limitations when using the 192 kHz setting
If the OCTA-CAPTURE’s sampling frequency is set to 192 kHz, its operation will be limited as listed below.
- Only INPUT 1–4 and OUTPUT 1–4 can be used.
- Direct Mixer A will be the only direct mixer available.
- Reverb will be unavailable.
- The patch bay will be disabled.
- The output settings will be fixed at the four channels OUT 1-2: Direct Mixer A and OUT 3-4: WAVE OUT 3-4. The inputs will be fixed at INPUT 1–4.
- The digital input/output jacks cannot be used.
- A second OCTA-CAPTURE unit cannot be used.
To alleviate this, use a sample rate of 96kHz or smaller.
- If using audio software, change the sample rate of the audio project you're working on. The OCTA-CAPTURE will automatically change it's sample rate to match the audio project. Check the documentation of the audio software or contact the software manufacturer for these instructions.
- If using the OCTA-CAPTURE without software, change this in the OCTA-CAPTURE itself:
https://www.roland.com/us/support/knowledge_base/360004896171/