DJ-505 System Program ver. 1.11
Procedure for the update
Caution
You must not rename the extracted file.
Never turn off the DJ-505's power while the update is in progress. Otherwise the system program or the DJ-505 itself may be destroyed.
Please install the extracted system program file "Dj202-505_C0A-up.bin" into your DJ-505 according to the following procedure.
Hold down the [CLEAR] button and turn on the power.
Connect the computer to the DJ-505's USB port by a USB cable.
Open the "Roland" drive folder in your personal computer.
The DJ-505 will show up as "Roland" like a USB stick or external hard drive.
Copy DJ202-505_C0A_up.bin from the "dj202505_sys_110" folder into the "Roland" drive by dragging and dropping it.
* Do not copy the "dj202505_sys_110" folder.
After copying the file is completed, remove the USB drive from the personal computer.
With Windows
Right-click on the "Roland" icon in My Computer and execute "Eject."
With Mac
Drag the "Roland" icon to the Trash icon in the Dock.
* Depending on the computer setup you're using, ejecting the USB drive might cause the update to start.
Disconnect the USB cable.
The update starts automatically.
The performance pads flash while the update is in progress.
When the performance pads stay lighted, the update is complete.
Detach the USB cable and turn off the power.
* The performance pads might flash at the first startup after the update. This is not a malfunction; without turning off the power, wait for the unit to start up.
After power cycling the DJ-505, turn off the DJ-505 and perform a Factory Reset.
Returning to the Factory Settings (Factory Reset)
The system settings and TR-S patterns stored in the DJ-505 can be returned
to their factory-set state (factory reset).
1. While holding down the [LOAD] button in the left side (L channel)
of the browser section, and press the [POWER] switch to turn on
the power.
The display indicates “FACT ,” and the [START/STOP] button of the TR-S
section blinks.
* If you decide to cancel the operation, turn off the power.
2. Press the blinking [START/STOP] button.
Factory reset begins.
When the display indicates “CPLT,” factory reset is complete.
NOTE
Never turn off the power until the display indicates “CPLT .”
3. Turn the DJ-505’s power off and then on again.