Click the link and download DJ-202 System Program 1.11 and follow the instructions below.
NOTE: The DJ-202 must be on system version 1.10 or higher to work with Serato DJ Pro.
Please install the extracted system program file into your DJ-202 according to the following procedure.
1.While holding down the [ SYNC ] button in the mixer section, connect the DJ-202 and the computer using the USB cable and turn on the power.
2.Open the "Roland" drive in your personal computer. "Roland" will show up like an external drive.
3.Copy DJ202-505_C0A_up.bin in the "dj202505_sys_110" folder into the "Roland" drive by dragging and dropping it.
* Do not copy the "dj202505_sys_110" folder.
4.Eject the "Roland" Drive.
With Windows
Right-click on the "Roland" icon in My Computer and execute "Eject."
With Mac
Drag the "Roland" icon to the Trash icon in the Dock or click the arrow pointing up to the right of the drive.
5.Pressing the [ SYNC ] button in the mixer section starts the update.
The performance pads flash while the update is in progress.
When the performance pads stay lighted, the update is complete.
6.Detach the USB cable and turn off the power.
* The performance pads might flash at the first startup after the update. This is not a malfunction; without turning off the power, wait for the unit to start up. Detach the USB cable to turn off power.
7.Perform a Factory Reset.
Returning to the Factory Settings (Factory Reset)
The system settings and patterns stored in the DJ-202 can be returned to
their factory-set state (factory reset).
1. While holding down the [LOAD] button in the left side (L
channel) of the browser section, use a USB cable to connect
the DJ-202 to your computer, and continue holding down the
[LOAD] button until the SEQUENCER section’s [START/STOP]
button blinks.
* If you decide to cancel the operation, turn off the power.
2. Press the blinking [START/STOP] button.
Factory reset begins.
The MASTER level indicator blinks, and then all buttons and pads are lit.
NOTE
Never turn off the power while the MASTER level indicator is blinking.
3. After the factory reset is complete, disconnect the USB cable to
power-off the DJ-202.